[HomeLab] – Copy VM from one ESXi host to another

I recently decided that it is time to setup a new homelab. The old server is about 10 yrs old. The hardware does not allow any upgrade in CPU and Ram. VMWare ESXi was version 6.5, but I could not upgrade to version 6.7 because the network card was not in the list of supported NICs and so the upgrade failed. Last, but not least, the power consumption was at 200W.

The new HomeLab has the following components

It took less than 30 minutes to assemble the NUC and install VMWare ESXi 6.7. ( + 15 minutes to drive to the local hardware store to grab an USB keyboard once I realized that I would need one for the setup )

Today, I migrated the existing VMs from the old host to the new one.

ESXi does not include VMotion. VMotion costs a lot of money.
I had read some articles which claimed to be best practice. But to be honest, using Veeam or SCP are not, what I consider “best” practice. I tried SCP, but it was so slooooow. Even a 50GB VM was estimated 11 hours to copy. And I have 30 VMs from just a couple of MB to 100GB.

I searched for a better solution. And I finally found it. VMware vCenter Converter Standalone Client.

You simply choose the “source” ESXi instance and select the VM to copy. Next you select the “target” ESXi. You can also choose, if the copy will be automatically updated to the target VM version.

It took only 30 minutes to copy a 50GB VM. Another 100GB VM was copied in 20 minutes.

The whole migration was done in only 5 hours. Not bad, isn’t it.


One thought on “[HomeLab] – Copy VM from one ESXi host to another

  1. Hello, it do you know if VMware vCenter Converter Standalone Client runs on linux and if so from a console ?
    It wasn’t clear when I looked.
    ta, Sean

Comments are closed.